[Pw_forum] QE: install problem, 4.2.1

[ac.rain at inbox.com]

Hi Paolo, I put the values into the configure and all looks well, not a single error. much appreciated, thank you.

./configure MPIF90=mpif90 CC=gcc F90=gfortran F77=gfortran

make all 2>&1 | tee makeall.log

regards,
nick - Linux Administrator

> -----Original Message-----
> From: giannozz at democritos.it
> Sent: Wed, 10 Nov 2010 08:35:50 +0100
> To: pw_forum at pwscf.org
> Subject: Re: [Pw_forum] QE: install problem, 4.2.1
> 
> 
> On Nov 10, 2010, at 4:31 , ac.rain at inbox.com wrote:
> 
>> the following I put in there
> 
> you shouldn't put there anything: configure will do the job
> 
>> and it seemed to compile most things.
>> 
>> MPIF90 = mpif90
>> F90 = gfortran
>> CC = gcc
>> F77 = gfortran
>> 
>> the "make all" output looks good now except for some output lines
>> that say "make[2]: g: Command not found".
> 
> so it doesn't look good
> 
>> So then I added a specification for "LD = ld" in the make.sys and
>> it seemed to break it
> 
> you shouldn't add anything to make.sys
> 
> P.
> ---
> Paolo Giannozzi, Dept of Chemistry&Physics, Univ. Udine
> via delle Scienze 208, 33100 Udine, Italy
> Phone +39-0432-558216, fax +39-0432-558222
> 
> 
> 
> 
> _______________________________________________
> Pw_forum mailing list
> Pw_forum at pwscf.org
> http://www.democritos.it/mailman/listinfo/pw_forum

____________________________________________________________
Send any screenshot to your friends in seconds...
Works in all emails, instant messengers, blogs, forums and social networks.
TRY IM TOOLPACK at http://www.imtoolpack.com/default.aspx?rc=if2 for FREE