[Pw_forum] QE: install problem, 4.2.1

[ac.rain at inbox.com]

Hi Paolo, yes that was the problem. it seems configure writes over make.sys, the following I put in there and it seemed to compile most things.

MPIF90 = mpif90
F90 = gfortran
CC = gcc
F77 = gfortran

the "make all" output looks good now except for some output lines that say "make[2]: g: Command not found".

So then I added a specification for "LD = ld" in the make.sys and it seemed to break it, make all now shows many "undefined references to `'" messages before failing at libiotk again.

do I need to have something in the LD_LIBS = section of the make.sys ? or should I put it back to how it was with a blank LD= and ignore the g: error.

the LD_LIBS line is not specified, the LDFLAGS line is set to -g.

thanks,

nick

> -----Original Message-----
> From: giannozz at democritos.it
> Sent: Tue, 09 Nov 2010 18:01:33 +0100
> To: pw_forum at pwscf.org
> Subject: Re: [Pw_forum] QE: install problem, 4.2.1
> 
> ac.rain at inbox.com wrote:
> 
>> export MPIF90=mpf90
> 
> I think this is the problem: "mpf90" is not in the path or not
> existent and "configure" gets an empty string when it checks if
> it exists and works
> 
> P.
> --
> Paolo Giannozzi, Democritos and University of Udine, Italy
> _______________________________________________
> Pw_forum mailing list
> Pw_forum at pwscf.org
> http://www.democritos.it/mailman/listinfo/pw_forum

____________________________________________________________
Send your photos by email in seconds...
TRY FREE IM TOOLPACK at http://www.imtoolpack.com/default.aspx?rc=if3
Works in all emails, instant messengers, blogs, forums and social networks.